HomeMy WebLinkAboutBLD2011-00577 Final Heat Pump - BLD Permit / Conditions - 1/27/2012 Inspection Line(360)427-7262
MASON COUNTY DEPT. OF COMMUNITY DEVELOPMENT Phone: (360)427-9670, ext. 352
Mason County Bldg. 3 426 W. Cedar P.O. Box 186
Ir Shelton, WA 98584
flo
MECHANICAL PERMIT BLD2011-00577
OWNER: TONY, HUBERT RECEIVED: 7/13/2011
CONTRACTOR: HOOD CANAL HEATING & COOLING (360)275-4992 LICENSE: HOODCHCO05DB EXP: 3/ ISSUED: 7/13/2011
SITE ADDRESS: 1 �Q NE�,FAIR MANOR DR BELFAIR EXPIRES: 1/13/2012
PARCEL NUMBER: �t0p4
LEGAL DESCRIPTION: S1/2 N1/2 SE NW LOT: 4 OF SP#2319 SURVEY 34/67
PROJECT DESCRIPTION: DIRECTIONS TO SITE:
HEATPUMP
General Information Setback Information
Type of Use: SF Insp.Area: Front: Ft. Shoreline: Ft.
Type of Work: MEC Fire Dist.: 2 Rear: Ft. Slope: Ft.
Side 1: Ft.
Valuation: Side 2: Ft.
Mechanical Fixtures FEES
• Type Qty. Type By Date Amount Receipt
Heat Pump 1 Mechanical Permit Fee GMM 7/13/2011 $36.50 S120110000(
Furnace<100K 1 Mechanical Base Fee GMM 7/13/2011 $28.50 S120110000(
Total $65.00
BLD2011-00577 Please refer to the following pages for conditions of this permit. Page 1 of 4
CASE NOTES FOR
BLD2011-00577
CONDITIONS FOR
BLD2011-00577
1) Contractor registration laws are governed under RCW 18.27 and enforced by the WA State Dept of Labor and Industries, Contractor Compliance
Division. There are potential risks and monetary liabilities to the homeowner for using an unregistered contractor. Further information can be obtained at
1-800 IMZ—'—
2. The person signing this condition is either the homeowner, agent for the owner or a registered contractor according to WA state law.
X
2) Owner
nt is responsible to post the assigned address and/or purchase and post private road signs in accordance with Mason County Title 14.28.
3) ALL FURNACE INSTALLATIONS SHALL MEET THE MINIMUM EFFICIENCIES SET FORTH IN THE CURENT EDITION OF THE WASHINGTON
STATE ENERGY CODE (WSEC). ANY PORTION OF THE MECHANICAL SYSTEM THAT IS ALTERED OR REPLACED SHALL MEET THE
MINIMYVJ TANDARDS SET FORTH IN THE WSEC AND INTERNATIONAL MECHANICAL CODE.
X jl(J�
4) A permanent certificate, completed by the builder or registered design professional, shall be posted within three feet of the electrical distribution panel.
The certificate shall list the predominant R-values of insulation installed in or on ceiling/roof, walls, foundation (slab, basement wall, crawlspace wall
and/or floor), and ducts outside the conditioned spaces; U-factors for fenestration; and the solar heat gain coefficient(SHGC) of fenestration. Where
there is more than one value for each component, the certificate shall list the value covering the largest area. The certificate shall list the type and
efficiency of heating, cooling, and service water heating equipment, duct leakage rates including test conditions as specified in WSEC Section 503.10.2,
and air leakage results if a blower door test was conducted.
Building envelope air leakage control shall be considered acceptable when tested to have an air leakage less than 0.00030 Specific Leakage Area (SLA)
when tested with a blower door at a press of 50 Pascals (0.2 inch w.g.). Testing shall occur at any time after rough in and after installation of
penetrations of the building envelope, including penetrations for utilities, plumbing, electrical, ventilation, and combustion appliances and sealing thereof.
The blower door test results shall be recorded on the permanent certificate required located near the electrical distribution panel. Air leakage testing is
not required for additions less than 750 square feet. Reference WSEC 105.4 Certificate and 502.4.5 Building Air Leakage Testing.
Compliance certificates are available online at the WSU Energy program website titled, "WSEC 2009 Certificate" and are available in Y<or%sheets.
The Mason County Permit Center will also have some available.
X W—,7
5) All construction must meet or exceed all local ordinances and the international codes requirements as adopted and amended by Mason County and the
State of Washington. Occupancy is limited to the approved and permitted classification. Any non-approved change of use or occupancy would result in
permit rev F
X I/�
BLD2011-00577 Please refer to the following pages for conditions of this permit. Page 2 of 4
6) Installation of heating equipment in a single-family residence shall meet the requirements of the current Washington State Energy Code, applicable
sections of the IRC and IMC.
Heating equipment shall be sized in accordance to IRC, Section M1401. Heating and design load calculations for the purpose of sizing HVAC systems
are required and shall be calculated in accordance with accepted practice, including infiltration and ventilation. Design calculations shall be available for
inspection during inspection.
Referencing IRC M1601.4, all ducts, air handlers, filter boxes, and building cavities shall be sealed. All joints of duct systems and seams shall be made
substantially air tight by means of tapes, mastics, liquid sealants, gasketing or other approved closure systems. Closure systems used with rigid fibrous
glass ducts shall comply with UL181A and shall be marked 181A-P for pressure-sensitive tape, 181A-M for mastic or 181 A-H for heat-sensitive tape.
Closure systems used with flexible air ducts and flexible air connectors shall comply with UL181 B and shall be marked 181 B-FX for pressure-sensitive
tape or 181 B-M for mastic. Duct connections to flanges of air distribution system equipment or sheet metal fittings shall be mechanically fastened.
Mechanical fasteners for use with flexible nonmetallic air ducts shall comply with UL 181 B and shall be marked 181 B-C. Crimp joints for round metal
ducts shall have a contact lap of at least 1-1/2 inches (38 mm) and shall be mechanically fastened by means of at least three sheet-metal screws or
rivets equally spaced around the joint. Closure systems used to seal metal ductwork shall be installed in accordance with the manufacturer's installation
instructions.
Duct tape is NOT permitted as a sealant on any ducts. When ducts are located in unheated spaces the ducts hall be insulated to R-8
DUCT TIGHTNESS TESTING shall be conducted by person(s) trained to perform such testing. A signed affidavit documenting test results in
accordance to WSEC Section 503.10.3 shall be provided to the Mason County Building Department prior to the final occupancy inspection. Affidavit
forms are available on at the WSU-Energy Program website titles, "Duct Leakage Affidavit"or"Duct Leakage Testing Results (Existing Construction)."
Duct tightness testing is not required if the air handler and all ducts are located within the heated space.
All heating equipment shall meet the requirements of the National Appliance Energy Conservation Act(NAECA)and be so labeled. (WSEC503.4) or in
accordance to WSEC Section 1411.
,^
X 1'V Z1
7) CONSTRUCTION PROCESS TO BE FIELD CORRECTED AS REQUIRED PER MASON COUNTY BUILDING DEPARTMENT AND THE ADOPTED
BUILDING CODE.
The construction of the permitted project is subject to inspections by the Mason County Building Department. All construction must be in conformance
with the international codes as amended and adopted by Mason County. Any corrections, changes or alterations required by a Mason County Building
Inspect
�e made prior to requesting additional inspections.
X
8) All building permits shall have a final inspection performed and approved by the Mason County Building Department prior to permit expiration. The failure
to request a final inspection or to obtain approval will be documented in the legal property records on file with Mason County as being non-compliant with
Mason mc_--
rdinances and building regulations.
X
9) All permits expire 180 days after permit issuance, or 180 days after the last inspection activity is performed. The Building Official may extend the time
for action for a period not exceeding 180 days, upon the receipt of a written extension request indicating that circumstances beyond the control of the
permit holder have prevented action from being taken. No more than one extension may be granted.
X J1'Z —
BLD2011-00577 Please refer to the following pages for conditions of this permit. Page 3 of 4
10) By definition, propane tanks and heatpumps are structures, which must meet setback conditions. Please check your"Approved Site Plan"to ensure
these struc
tures meet the setback conditions listed.
X
This permit becomes null and void if work or construction authorized is not commenced within 180 days, or if construction or work is suspended for a period of 180 days at any
time after work is commenced. Evidence of continuation of work is a progress inspection within the 180 day period. Final inspection must be approved before building can be
occupied. Proof of continuation of work is by means of a progress inspection.The owner or the agent on the owners behalf, represents that the information provided is accurate
and grants employees of Mason County access to the above described property and structure for review and inspection.
OWNER OR AGENT: DATE:
BLD2011-00577 Please refer to the following pages for conditions of this permit. Page 4 of 4
W
o CONCRETE Gas Piping MANUFACTURED HOME C
o Interior-Date By W
Footings/Setbacks Exterror_Date By
Ribbons m
0 Date By INSULATION Date By
4 Foundation Walls Set-up —i
8G/SLAB INSULATION Set-up
Date BY Y
Date B Date BY Z
FRAMING Floors FIRE DEPARTMENT
Date
BY Date By
Date By Walls
PLUMBING Date By DECKS
Date By
Groundwork Vault TANKS
Date
Date BY Attic BY Date By
D.W.V Date B, OTHER
Date By DRYWALL Type.
Date By
Water Line Date By
Type:
v Date By Int.Brace Wall Date B
— y r
CD MECHANICAL �i�sep�at�«�ate By
FINAL INSPECTION o
Date By Date BY Date I LZ7 /Z BY a
O
Pass or Request Inspect.
CD Type of Insp. Fail Date Date Done By Comments
v
a
a
o'
_
N
O
tn
CD
3
01
(D
0
PERMIT NO.
MASON COUNTY
PLUMBING/MECHANICAL PERMIT APPLICATION
426 W. Cedar• P.O. Box 186, Shelton, WA 98584
Shelton (360)427-9670•Belfair(360)275-4467• Elma(360)482-5269
On the web www.co.mason.wa.us
APPLICANT INFO MATION CONTRACTOR I R TION
Owner r Company Name
Mailing A es I r" _� yr Maili A ress J i J
City State ld-_Zip Coded — City W yr —State Zip Code i,S.3sr
Phone�lo� ' ���'Other Ph.2UO `.1a5 J7`Ik Phone - Other Ph.
Lien/Title Holder Contractor Reg # xp. _
E mail address E Mail Address < < '� Gaj •tU:�tl'1
Drivers Lic.# DOB Drivers Lic. # DOB
SEPTIC INFORMATION - Connect to New Septic Existing Septic Connect to Sewer System
Name of Sewer System
PARCEL INFORMATION- 12 Digit Parcel No `1 '` c� Fire istrict
Legal Description '1 t 1*1 O 0 A � ��9- t
Site Address(Please include street name,street number and pity) I ja k Y hNnu r rI V"e t r
Directions to site
Is property within 200'of Saltwater Lake River/Creek Pond
Wetland Seasonal Runoff Stream Slopes or Bluffs > 15%
TYPE OF JOB - New Add Alt Repair Other Use of Building
Location of Fixtures/Units - 1st Floor 2nd Floor Basement Garage Closet
PLUMBING FIXTURES(Show Number of each) MECHANICAL UNITS
Type of Fixture No. of Fixtures Fees Fuel Type:Electric_LPG__Natural Gas—Heat Pump
Toilets Type of Unit No.of Units Fees
Bathroom Sink Furnace
Bath Tubs Heatpumps X —
Showers Spot Vent Fan
Water Heater Propane Tank
Clothes Washer Gas Outlets
Kithen Sinks Wood/Gas/Pellet Stove
Dishwasher Kitchen Exhaust Hood
Hosebibs Dryer Vent
Other Other
Base Fee Base Fee
TOTAL PLUMBING TOTAL MECHANICAL
OWNER/BUILDER Acknowledges submission of inaccurate information may result in a stop work order or permit revocation.Acknowledgement of
such is by signature below.I declare that I am the owner,owners legal representative,or the contractor.I further declare that I am entitled to receive this
permit and to do the work as proposed in the application.I declare that I have obtained the permission from all the necessary parties.If permission is
required from any easement holder or any other party in interest regarding this application or the work proposed in the application,I have obtained
permission from them to apply for this permit and conduct the work proposed. The owner or agent on owners behalf,represents that the information
provided is accurate and grants employees of Mason County access to the above described property and structure for review and inspection.
PROOF OF CONTINUATION OF WORK IS BY MEANS OF A PROGRESS INSPECTION.
X Date: 7— -3—1
caner/Owners Representativ ntractor (indicate which one)
FOR OFFICIAL USE BEYOND THIS POINT
Accepted by: Planning Pd Ck# Date Bld Pd Receipt No.
DEPARTMENTAL REVIEW APPROVED DENIED NOTES
Building Department
Occ Group T e Constr.
Planning Department
Environmental Health Department
FEES
Plumbing & Base Fee Site Ins ection
Mechanical & Base fee UFC Plan Review Fee
Wood/Gas/Pellet Stove Fee Other
Violation Fee TOTAL FEES