HomeMy WebLinkAboutBLD2009-00084 Remodel - BLD Permit / Conditions - 7/14/2010 f
Inspection Line(360)427-7262
MASON COUNTY DEPT. OF COMMUNITY DEVELOPMENT Phone: (360)427-9670,ext.352
Mason County Bldg. 3 426 W. Cedar P.O. Box 186
Shelton,WA 98584
MECHANICAL PERMIT BLD2009-00084
OWNER: DAVID, BAYLEY RECEIVED: 2/9/2009
CONTRACTOR: LICENSE: EXP: ISSUED: 7/14/2010
SITE ADDRESS: 8761 E STATE ROUTE 106 UNION EXPIRES: 1/14/2011
PARCEL NUMBER: 322353200010
LEGAL DESCRIPTION: TR 1 OF LOT 4&T.L.
PROJECT DESCRIPTION: DIRECTIONS TO SITE:
OVER 50% REMODEL ON EXISTING RESIDENCE WITH A NEW 80 SQ SR 106 to address.
FT NEW ADDTION
General Information Setback Information
Type of Use: SF Insp.Area: Front: S 10.0 Ft. Shoreline: Ft.
Type of Work: NEW Fire Dist.: 6 Rear: N 15.0 Ft. Slope: Ft.Side 1: E 5.0 Ft.
Valuation:
Side 2: W 5.0 Ft.
Mechanical Fixtures FEES
Type Qty. Type By Date Amount Receipt
Exhaust Hood 1 Plan Check Fee KKK 2/9/2009 $722.38 S220090000
Fireplace 1 Planning Review Fee KKK 2/9/2009 $205.00 S220090000
Furnace<100K 1 EH Plan Review KKK 2/9/2009 $41.00 S220090000
Gas Outlets 3 EH Plan Review CEW 4/17/2009 $62.00 S120090000
Ventilation Fan 3 Water Adequacy Plan Review CEW 4/17/2009 $41.00 S120090000
Propane Stove 1 Building State Fee LDK 12/10/200 $4.50 S120090000
Dryer Vent 1 Plan Check Fee LDK 12/10/200 $722.38 S120090000
Building Permit Fee LDK 12/10/200$1,111.35 S120090000
Mechanical Permit Fee LDK 12/10/200 $67.50 S120090000
Mechanical Base Fee LDK 12/10/200 $28.50 S120090000
Plumbing Permit Fee LDK 1 2/1 012 0 0 $93.20 S120090000
Plumbing Base Fee LDK 12/10/200 $24.70 S120090000
Mechanical Base Fee GMM 7/14/2010 $9.00 S120100000
Mechanical Permit Fee GMM 7/14/2010 $152.20 5120100000
Total $3,284.71
BLD2009-00084 Please refer to the following pages for conditions of this permit. 1 of 5
1
CASE NOTES FOR
j BLD2009-00084
CONDITIONS FOR
BLD2009-00084
1) Owner/Agent is responsible to post the assigned address and/or purchase and post private road signs in accordance with Mason County Title 14.28.
X 4bL/2
2) The international code requires a fire apparatus access road for every facility, building, or portion of a building that is more than 150'from an approved
access road. Roads are required to meet the minimum Mason County Fire Marshal standards for Fire Apparatus Access Roads up to the point where
such roads connect with a county maintained public road or to another fire apparatus access road which connects to a county maintained public road.
X
T
3) All exterior wall cavities exposed during construction or remodeling work shall be insulated to the full depth of the wall cavity and inspected prior to
X covering. F ALLS THAT ARE NOT BEING REMOVED OR ALTERED.
4) The plan review check list and corrections are part of the approved plans and must remain thereto. It is the responsibility of the applicant to make the
corrections indicated on the plans. Once the plans are marked "APPROVED", they shall not be changed or altered without authorization from the Building
Official. The permit holder is responsible to retain the complete approved set of plans on site for the duration of the project. Failure to comply and/or
removal approved documents will result in failure of required building inspections.
(
l
5) All approved plans are required to be on-site for inspection purposes. If an inspection is called for and plans are not available on site, then approval will
not be granted. In addition, a re-inspection fee (refer to current fee schedule, minimum 1 hour)will be charged and must be collected by the Building
Department prior to any further inspections being performed or approvals granted.
XiJ
6) Contractor registration laws are governed under RCW 18.27 and enforced by the WA State Dept of Labor and Industries, Contractor Compliance Division.
There are potential risks and monetary liabilities to the homeowner for using an unregistered contractor. Further information can be obtained at
X 800-54 . The person signing this condition is either the homeowner, agent for the owner or a registered contractor according to WA state law.
7) Approved pe[dimensions and setbacks on submitted site plan. Setbacks are measured from the furthest projection of the structure.
X
8) All slabs within the heated space shall be insulated to a rWimum R-10 for at least 24". Monolithic slabs shall be insulated around the perimeter from the
top of the slab to the bottom of the footing XGj
BLD2009-00084 Please refer to the following pages for conditions of this permit. 2 of 5
9)' All exterior wall cavities exposed during construction or remodeling work shall be insulated to the full depth of the wall cavity and inspected prior to
t covering. X
10) SINGLE RAFTER JOIST ROOF REPLACEMENT SHALL BE INSULATED TO A MINIMUM OF R-30 ALLOWING FOR A MINIMUM OF ONE INCH
CONTINUONT-ED AIRSPACE ABOVE THE LEVEL OF INSULATION. max of 500 sgft
X
11) The"approved"site plan is required to be on-site for inspection purposes. If an inspection is requested and the"approved" site plan is not on site, then
approval will not be granted. In addition, a re-inspection fee (refer to current fee schedule, minimum 1 hour)will be charged and shall be collected by the
Building Department-prior� to any further inspections being performed or approvals granted.
X
12) Washington State Energy Code Compliance has been approved using the following:
Heat Type: Electric or other fuels, Compliance Method: Prescriptive option IV, Window(Max U-Factor):0.35, Skylight(Max U-Factor):0.58, Doors
(Type/Max U-Factor):0.20 or less, Wall insulation R-21, Floor insulation R-30, Ceiling Insulation R-38, Vault Insulation R-38 (see exception), Slab
Insulation R-10.
Exception: R-30 insulation may be installed, up to 500 sq. ft., in single rafter or joist vaulted ceilings where the distance of the top of the ceiling and the
underside of the roof-sbeathing is less than 12-inches and there is 1-inch vented airspace above the insulation.
XU
13) Per 2003 IRC -SECTION 1609 -WIND LOADS - 1609.1 Applications. Buildings, structures and parts thereof shall be designed to withstand the
minimum wind loads prescribed herein. Decreases in wind load shall not be made for the effect of shielding by other structures. Per FIGURE 1609
BASIC WIND QPEED, 3-SECOND GUST)the wind speed for Mason County is 85 MPH.
14) Per IRC -SECTION R905 - REQUIREMENTS FOR ROOF COVERINGS- R905.1 Roof covering application. Roof coverings shall be applied in
accordance bit .
_ X th
"plicable provisions of this section and the manufacturer's installation instructions.
15) Any changes in proposed construction shall be reviewed by the engineer or architect of record and submitted in writing to the Mason County Building
Department prior to construction. All engineering and/or architectural documents are a part of the approved set of plans and shall remain attached
thereto. If documents are removed, approval will not be granted. In addition, a re-inspection fee (refer to current fee schedule, minimum 1 hour)will be
X charged andZsh,111. collected by the Building Department prior to any further inspections being performed or approvals granted.
16) All construction must meet or exceed all local ordinances and the international codes requirements as adopted and amended by Mason County and the
State of Washington. Occupancy is limited to the approved and permitted classification. Any non-approved change of use or occupancy would result in
permit revoca
17) All changes to"approved" building plans that effect compliance with the international codes as amended and adopted, or any other Mason County
X
rdinance or reaultayr ust be reviewed and approved by Mason County prior to construction.
BLD2009-00084 Please referto the following pages for conditions of this permit. 3 of 5
18) CONSTRUCTION PROCESS TO BE FIELD CORRECTED AS REQUIRED PER MASON COUNTY BUILDING DEPARTMENT AND THE ADOPTED
BUILDING CODE.
The construction of the permitted project is subject to inspections by the Mason County Building Department. All construction must be in conformance
with the international codes as amended and adopted by Mason County. Any corrections, changes or alterations required by a Mason County Building
X Inspector shall ��de prior to requesting additional inspections.
19) All property lines shall be clearly identified at the time of foundation inspection. X �
20) All building permits shall have a final inspection performed and approved by the Mason County Building Department prior to permit expiration. The failure
to request a final inspection or to obtain approval will be documented in the legal property records on file with Mason County as being non-compliant with
Mason Coun rdinagces and building regulations.
21) All permits expire 180 days after permit issuance, or 180 days after the last inspection activity is performed. The Building Official may extend the time for
action for a period not exceeding 180 days, upon the receipt of a written extension request indicating that circumstances beyond the control of the permit
holder have preI
t� tion from being taken. No more than one extension may be granted.
X
22) Pressure treated wood manufactured after January 1, 2004 may contain high concentrations of copper which could quickly corrode metal fasteners,
connectors, and flashi Install metal connectors approved for contact with the new types of pressure treated material.
xc',�
23) Retaining walls needed to support a surchasucb-as structures, roads, or to support slopes, shall require a separate building permit and approval prior
rge,
to construction of the retaining wall. X C 5
24) Landings and stairs must meet the same setback conditions as any permitted structure; and, must be shown on your site plan. Please check your
"Approved Sit z I n" ensure these structures are shown and meet the setback conditions listed.
25) LETTER FROM ENG�NEER FOR FOUNDATION ON RECORD IN FILE COPY.
X ) L_J>
26) SWG2009-00066 installation must be approved prior to temporary/final occupancy.
X ��
BLD2009-00084 Please referto the following pages for conditions of this permit. 4 of 5
This permit becomes null and void if work orconstruction authorized is not commenced within 180 days,or if construction or work is suspended for a period of 180 days at any time after work is
commenced. Evidence of continuation of work is a progress inspection within the 180 day period. Final inspection must be approved before building can be occupied. Proof of continuation of
work is by means of a progress in pection.The owner or the agent on th owners behalf,represents that the information provided is accurate and grants employees of Mason County access to
the above described property an ructure.for review and inspection.
OWNER OR AGENT: DATE:
BLD2009-00084 Please referto the following pages for conditions of this permit. 5 of 5
W
o CONCRETE MECHANICAL MANUFACTURED HOME D
CDm Footings/Setbacks Dace ���� /� BY Ribbons , r
Gas Piping I / M
o Interior Date By interior-Date W By Date By
00 Exterior Date BY(�� Exterior-Date By Set-up p
Point Load/Isolated Footings INSULATION Date By <
Date By aBaG�I SLAB INSULATION By FIRE DEPARTMENT
Foundation Wails Floors Date By
Date By Data By DECKS
FRAMING Walls Date By
Date? `f ./a By / Data _ By PROPANE TANKS
PLUMBING vault Data -T-/ -/a By
Date By OTHER
Groundwork Type
Attic /
Data 2 j/7 Y�0 B Date 7 ����( � BY
y Date By
o.W.v DRYWALL Type:
Int Brace Wall Date By W
Date 7 0 BY Date By FINAL INSPECTION
v Water Line Fire Separation N
Date By Date By Date By%,���-- c
Pass or Request Inspect. c
5 Type of Insp. Fail Date Date Done By Comments o
(DSk
_ �jkL� � ffi f,�59 74 1,J1,P Zhl&S iQl C
0
Siµ h,.�` �— �— h��✓ � �+11, �� /'1 �1(�
Sll
4acl S C(J�S'�i�ardf fc�CD
8
)4ek.,% (, W,il Y3�
o taKt
0
CA
N
WPI,L —L f ALI"!(r
/ivsv� n. .S -,I -10 •19-1(9
Strk�EA PAu
,Z�
J�as I��a 4r a5 F-3//D `7-1/D
0
7/14/2010
Conditions Associated With 8:18:12AM
Ir Case#: BLD2009-00084
flo
Permit Condition Status Updated
item# Code Title Status Changed By Tag Date By
26) 1002 ADDRESS/ROAD SIGNING NOT MET 2/1 1/2009 ARC
Owner/Agent i responsible to post the assigned address and/or purchase and post private road signs in
accord wit ason County Title 14.28.
X
27) 5095 FUEL P ING NOT MET 7/14/2010 GMM
Fuel piping shall be inspected after the installation of fuel piping is complete,and before the attachment of
fixtures,appliances or shut-off valves. At the time of inspection the test pressure shall be no less than 10 psi
held for no le tha 15 minutes. Appliances to be attached to the fuel piping system shall not be used until the
final insp been performed and approved by a Mason County building inspector.
X
28) 5085 PROPANE TANK, 125-500 GALLONS NOT MET 7/14/2010 GMM
All propane tanks must be installed in accordance with the International Fire Code and all applicable Mason
County ordinances. All Propane tanks between 125 and 500 gallons must be located a minimum of 10'from
any building,possible source of ignition(electrical outlets,electrical fixtures, compressors,etc), and/or any
weeds,grass,brush,trash or any other similar combustible materials. Setback to the public way, or access
easements shall be the greater of 25-ft or as specified in the Mason County Development Regulations. Setback
to prope lines shall be the greater of 10-ft or as specified in the Mason County Development Regulations. If
a propa a is posed to probable vehicular damage,protective bollards must be installed.
X
Page 4 Of 4 CaseConditions..rpt